I didn't find any instructions online when I did mine but it's a pretty straightforward job. If you run into anything just post questions and I'll try to answer.
So for anyone installing the mud flaps, a few tips from my experience:
For the rear ones you WILL need to remove the entire plastic wheel well in order to put the metal screw retaining clips onto the holes in the bumper. From memory there are four Philips head screws (three of them on the bottom) and two plastic plugs on each side, plus a strangely shaped large plastic nut on only the right (passenger) side. Once these are removed, just pull the plastic toward the inside of the car to remove it.
The front is much simpler, you need only take out the three plastic clips on the front of the plastic panel to enable you to reach inside the rocker panel to push the rubber hole plug out of the bottom.
I'll post some pictures later, but hopefully this helps some to anyone who is working on it.
Thanks Mm, I have been told there are installation instructions on Toyotas TIS electronic site. I tried to did around but it seems more than I want to do for simple mud guards.
Yeah it's just about one of the easiest things you can do to your car, just all simple screws in place that need to be removed to do the job. Rarely is it anything more and I haven yet to see that for myself.
Keep us posted on how that goes.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Scion IA Forum
7.3K posts
1.6K members
Since 2015
A forum community dedicated to Scion IA owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, troubleshooting, maintenance, and more!